|
The beloved kangaroo from Australia Tamiya presents the robot replica of the beloved kangaroo from Australia. This amazing kangaroo-robot jumps by moving its rear legs simultaneously to go forward. When walking slowly, it also uses its front legs (just like they do down under) and when running quickly, it uses its tail for balance. Legs and body on which the gearbox is mounted employ transparent-colored parts, giving the kangaroo a funky look. Reverse switch is also transparent, giving you a peek at the kangaroo's internal mechanisms.
All you need included Assembly is very simple with use of screws and snap-lock parts. Cable ends are rubber capped with cut areas pre-marked for easy wiring.
When using high-speed gearbox, the kangaroo walks standing on its tail and rear legs. A gearbox transforms the motor movement to make the kangaroo's rear legs move. You can choose between two different gears for gearbox assembly. When using the low speed gearbox, rods are attached to the lower holes of front legs and kangaroo walks standing on its tail.
Low-speed gearbox makes the kangaroo walk using its front and rear legs When using the low speed gearbox, rods are attached to the upper holes of front legs. Changing rod position using different holes in the crank plate gives you 4 different speed possibilities within slow speed mode. When walking slowly, it impressively imitates a real kangaroo's movement.
Altering tail position makes kangaroo change direction Changing the position of the tail allows the kangaroo to keep balance during high-speed running and enables it to change direction. Putting the tail straight will make the kangaroo go straight but setting it to the right/left will make the kangaroo turn to the right/left.
Playing with the Kangaroo Avoid running over slopes, bumpy roads or longhaired carpet. Run on flat, smooth surfaces. Watching its humorous movement will provide you with loads of fun.
Basic Specifications
- Total length: 180mm
- Total weight: 95g (w/ out batteries)
- Body material: ABS resin
- 2 gears included, one for high speed and one for low speed.
- Motor and reverse switch also included.
- Screwdriver for assembly is included.
- Requires one R6/AA/UM3 battery (sold separately).
- Continuous running time with Alkaline battery: 3hrs. at low speed/1hr. at high speed.
 |
